The 4-Channel Bus Dry Contact Input Module allows up to four toggle switches or other dry contact closures to trigger lights, scenes or any other automation event in a Control4 system.
The Control4 DIN-Rail 8-Channel Adaptive Phase Dimmer controls up to eight loads from one module in the Control4 system. It is an adaptive phase dimmer, so each channel supports a variety of load types including incandescent, halogen, electronic low-voltage (solid-state) transformer, magnetic (iron core) low-voltage transformer, fluorescent, compact fluorescent, LED, and motor. The DIN-Rail 8-Channel Adaptive Phase Dimmer automatically detects the load type and sets the appropriate dimming mode.
The Control4® 8-Port Ethernet Switch is a standard 8-port 10/100 switch that allows a single Ethernet CAT5e cable to be pulled into a lighting panel, and then distributed to up to seven (7) other Control4® panelized lighting devices including Dimmer, Relay, and Bus Ethernet Bridge Modules within the panel.
The Control4® 8-Channel Relay controls up to eight (8) high in-rush loads from one module in the Contro4® system. Each channel supports a variety of load types including Incandescent, Halogen, Electronic Low Voltage Transformers, Magnetic Low Voltage Transformers, Fluorescents, Compact Fluorescents, LEDs and Motors.
The Control4 DIN-Rail 8-Channel Relay Switch controls up to eight high in-rush loads from one module in the Control4 system. Each channel supports a variety of load types, including incandescent, halogen, electronic low-voltage transformers, magnetic low-voltage transformers, fluorescents, compact fluorescents, LEDs, and motors.
The Control4® 8-Channel 0-10V Dimmer controls up to eight (8) 0-10V dimmable fluorescent ballasts or LEDs. Each channel can control up to 50 ballasts. Individual 0-10V lights can be programmatically tied to a corresponding channel on a Control4® 8-Channel Relay module for on/off control of the ballast or LED when needed. Alternatively, the Control4 8-Channel 0-10V Dimmer module also has eight (8) low-voltage outputs for triggering external power relays.
The Bus Ethernet Gateway is the connection point for all wired keypads and other devices on the Control4 Centralized Lighting keypad bus. The Ethernet Gateway is designed to convert RS-485 communication to Ethernet for usage with Centralized Lighting modules and a Control4 controller.
The Control4® Bus Power Supply is intended for use in a Control4 system. This device installs in a Control4 Panelized Lighting panel or in any standard DIN rail panel with 35mm rails. The Bus Power Supply provides the power to the Bus Ethernet Gateway (C4-DIN-BEG) and Control4 wired keypads (C4-KCB-xx and C4-SKCB-xx) in a Panelized Lighting system.
Sesjonen din har nå utløpt. Vennligst klikk "OK" for å oppdatere siden og unngå tap av eventuelle ikke-lagrede data. Dersom du var logget inn, må du nå logge inn på nytt.